Kleen-Rite Cooling Tower Systems
	Quick and Easy To Install
	Aerodynamically Designed
	Propeller Type Fan Blades
	Industrial Rated and Proven
	High Heat Transfer Efficiency
	Non-rusting FRP Casting and Basin with a Streemline Look

Cooling Tower Systems
Setting the Standard for Performance

Design Features:
The non-rusting FRP casing and basin, circular in shape, eliminates special installation requirements. Prevailing wind directions will not affect tower performance. Lightweight and compact, the Kleen-Rite Cooling Tower provides quick and easy installation.

Casing:
Easy access through casing simplifies cleaning. Individual fiberglass panels are stainless steel bolted together for periodic wash down and general clean-up. The Kleen-Rite Cooling Tower is designed for durability and long life even under the most severe environmental weather conditions.

Fan Blades:
Aerodynamically designed propeller type fan blades are used to conserve power and assure quiet operation. The Kleen-Rite Cooling Tower features a factory balanced, direct drive ABS plastic blade.

Water Distribution System:
Kleen-Rite uses an ABS plastic sprinkler with stainless steel shaft. This sprinkler head has little or no head pressure loss and requires minimum maintenance.

Inlet Louvers:
Non-rusting PVC plastic mesh provides easy access to sump while preventing foreign objects from entering water basin.

Fill Material:
Honeycomb heat embossed PVC is formed to permit high heat transfer efficiency. The Kleen-Rite fill is suitable for operation with inlet water temperatures of 125°F. For higher temperatures, contact your Kleen-Rite representative.

Engineered for Cost Efficiency

1. Fan Motor:
   Weatherproofed and totally enclosed allowing for less noise and more efficient long-term performance.
2. Sprinkler Pipes:
   Sturdy PVC material pierced with closely-spaced holes allowing thorough distribution of water in a rotating spray covering the entire surface of the filler.
3. Housing Panel and Water Basin:
   The round design permits maximum air intake regardless of wind direction. The housing panels and water basin are built of fiberglass reinforced plastic ensuring rust-free, long-term performance even under the most severe environmental conditions. A large-capacity, durable water basin constructed from rust-proof fiberglass. reinforced plastic guarantees low maintenance and long-term operation.
4. Inlet/Outlet Pipes:
   Efficient operation results from the smooth pumping of recirculated water through the stand pipe and up into the sprinkler pipes. A large diameter outlet pipe draws a constant supply of cooled water from the basin to serve the facility.
5. PVC Filler:
   The efficiently designed PVC filler creates a surface area that allows for maximum dispersion of water creating a superior cooling effect.

Cooling Tower System Specifications

Dimensions and Pipe Connections Piping: CT-10 - CT-60 Thread Type CT-70 - CT-150 Flange Type Note: *Electrical specifications are 110/220/3/60 for CT-10 & CT-15; either 110/220/3/60 or 220/440/3/60 for CT-20; 220/440/3/60 for CT-25 – CT-150. Nominal flow is defined as rate of water cooled from 95°F to 85°F with 75°F wet bulb temperature.

CT-10 thru CT-30 CT-40 thru CT-150

Tower Capacities

Note:
Tons of Refrigeration at 250 BTU/MIN with 3 GPM/TON.

Send mail with questions or comments about this web site.
Copyright © 2006 Kleen-Rite, Member of the International Fabric-Care Institute.